1 1/2”
(38 mm)
2”
(50 mm)
15
14
model no.
058-9342-6
| contact us 1-888-670-6682
• Disconnect the tool from the compressed air source
before loading fasteners.
• Do not point the tool towards the operator or other
people while changing fasteners.
• Do not hold the tool with the trigger depressed while
changing the fasteners. Failure to comply will lead to
serious injury or loss of life.
DANGER!
Potential hazard that will result in serious injury or
loss of life.
NOTE:
Icons are colour-coded. Please refer the actual
tool for the specific colour.
WARNING!
Potential hazard that could result in serious injury or
loss of life.
• The use of any other types of fasteners will cause
the tool to jam. Failure to comply could lead to
serious injury or loss of life.
This MAXIMUM
®
Air-powered 2-in-1 Flooring Nailer accepts the
following size and type of fasteners.
ACCEPTABLE FASTENERS
Flooring staples (15 gauge)
Crown: 1/2" (12.7 mm)
Length: 1 1/2-2" (38-50 mm)
L-Shaped cleats/nails (16 gauge)
Length: 1 1/2-2" (38-50 mm)
NAIL TYPE ICONS
These Icons are used to select the proper nails for this specific nailer.
Fig. A
1
Loading fasteners
1. Disconnect the tool (1) from the air
supply (2) (Fig. A).
2
Fig. C
3. Release the pusher (1), so that it rests
on against the fasteners (2) to close the
magazine, until it comes into contact
with the fasteners and locks into position
(Fig. C).
1
Fig. D
2
4. Plug in compressor, turn it on, set the
pressure regulator to 90 PSI, and attach
one end of the air hose to the compressor
and the other end of the air hose (1) to
the tool (2). Use plumber’s tape to avoid
air leaks (Fig. D).
Fig. B
2. Take hold of the Air-powered 2-in-1
Flooring Nailer firmly with one hand.
Use the other hand to press the pusher
latch (1) on the magazine and slide it
back. Make sure you have the right
nails for your tool (See page 14). Insert
a strip of fasteners (2) into the magazine.
Ensure that the points of the fasteners
are facing down (Fig. B).
2”
2”
(50 mm)
1 1/2”
1 1/2”
(38 mm)
TM
15
1/2
