11
SprayMate HVLP ST610EU TNT
EU
17. Correction of Malfunctions
Malfunction
Cause
Remedy
No spray tanning
solution comes out
of the nozzle
•
Nozzle clogged
•
Material volume setting
turned too far anticlockwise
•
No pressure build-up in
container
•
Container empty
•
Feed tube loose
•
Feed tube clogged
➞
Clean
➞
Turn material volume
setting clockwise
➞
Tighten container
➞
Refill
➞
Insert
➞
Clean
Spray tanning
solution drips out
of the nozzle
•
Spray tanning solution has
accumulated on the air cap,
nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
➞
Clean
➞
Union nut tighten
➞
Change
➞
Change
Atomization too
coarse
•
Material volume setting
turned too far clockwise
•
Nozzle contaminated
•
Too little pressure build-up in
container
•
Air filter heavily soiled
➞
Turn material volume
setting anticlockwise
➞
Clean
➞
Tighten container
➞
Replace
Uneven spray
pattern
•
Spray tanning solution in the
container is running out
•
Nozzle seal worn
•
Air filter heavily soiled
➞
Refill
➞
Replace
➞
Replace
Excessive overspray
•
Distance too large
•
Material volume setting
turned too far clockwise
➞
Reduce distance
➞
Turn material volume
setting anticlockwise
Spray tanning
solution runs down
body
•
Too much spray tanning
solution applied
•
Spray paths overlap too much
•
Spraying distance too small or
spray movement too slow
➞
Carefully dab affected
points with a towel,
reduce flow setting if
required and lightly
overspray again