2.3
High-pressure part
The pump is envisaged for pumpage and compression of water or oil. The hydraulic
pressure can be determined by adjustment of the drive pressure.
Please, use the attached diagram for this purpose (Technical Data). The piston
frequency decreases with rising hydraulic pressure. Operate the pump at a low
frequency until the pump is fully primed with fluid and the hydraulic system is
ventilated.
The hydraulic pipework and accoutrements should be matched to the pump as
regards their pressure, cross-section and medium. The nominal width of pipework
should not be dimensioned smaller than the connection cross-section of the pump.
The suction diameter may only be reduced when fluid is charged under pressure.
The suction pipeline should be equipped with filter with a mesh size of max. 100
µ
m.
