Spangenberg International B.V.
– Rendementsweg 24P – 3641 SL Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
4
heating process by pressing the
SEALING TEMPERATURE
key on the control panel. This is to
prevent the heating process and to decrease wear and tear. Run the vacuum pump a few times, as
described later in this manual, and the machine is ready to use.
Control Panel
Programming
Please set every parameter first before operating the machine.
1. Connect the machine to the power supply, open the top cover and turn on the machine by pressing
the
ON
button
. You will see “--“ in the display.
2. Press the
SET
button, the
VACUUM
indicator lamp lights to enter the vacuum time. Press the
INCREASE
or
DECREASE
key to increase or decrease the vacuum time in the range of 0~99
seconds.
3. After the vacuum time is set, press the
SET
key and the
GAS
indicator lamp lights to enter nitrogen
filling time. Press the
INCREASE
or
DECREASE
key to increase or decrease the nitrogen filling
time in the range of 0~9.9 seconds.
Note: Some models do not have nitrogen filling function,
the machine will automatically switch to the sealing time setting.
4. Press the
SET
key, the lamp of
SEALING
lights to enter the sealing time. Press the
INCREASE
or
DECREASE
key to increase or decrease the sealing time in the range of 0~9.9 seconds. (First try
1.0-1.5 sec)
5. After the sealing time is set, press the
SET
key again, the
COOLING
indicator lamp lights to enter
the cooling time in the range of 0~9.9 seconds. (First try 2.0-3.0 sec)
6. After the cooling time is set, press the
SET
key again to finish the pa
rameter setting, and “--” is
shown in the display.
7. Press the
SEALING TEMPERATURE
key to change the sealing temperature. Press the
SEALING
TEMPERATURE
key multiple times to choose the correct temperature value. There are three
values:
“
HIGH
temperature”, “
MIDDLE
temperature” and “
LOW
temperature”. Attention: While
processing the state lamp lights and shows the red color when in sealing operation. If the state lamp
does not light, it means that there is no sealing temperature selected.
8. If your machine model has electric cover opening or pneumatic cover opening, we will preset the
return-air cover opening time. The time relay is usually installed inside the machine, timings normally
do not have to be altered.
9. Now every time that
you power on the machine “--“ is shown, now the machine will function in the
correct settings.
10. Remarks & Tips: You can speed up the vacuum packing process by placing a solid block into the
chamber. This to occupy chamber space, wich decreases the vacuum time needed.
