Spangenberg International B.V.
– Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
Troubleshooting (for user and technician reference)
This Ice Maker has a self-checking function, faults will be visable on the display panel by use of indicator lights.
The follow overview will help you understand the control panel and possible problems. However, only qualified
engineers should attempt to open or repair the machine. Contact your supplier when in doubt.
Note: If any problems occur, please wait untill the machine stops automatically.
Problem
Possible Cause
Possible Solution
The appliance does not work.
(no indicator lights illuminated)
•
The appliance is switched off.
•
The power supply is
interupted.
•
The voltage is not correct.
•
The ambient temperature is
below 6 °C.
➢
Switch on the appliance.
➢
Check the power supply, plug
in power cable.
➢
Use another power source.
➢
Make sure the ambient
temperature is above 6 °C.
The appliance does not work.
(only powerswitch is illuminated)
•
The voltage is not correct.
•
PCB Board is damaged.
➢
Use another power socket.
➢
Contact supplier
The appliance does not work.
(“ICE FULL” indicator is
illuminated)
•
Ice storage container is full.
➢
Remove ice from container.
The appliance does not work.
(“ICE FULL” and “FAULT”
indicators are illuminated)
•
Ice sensor defective or
disconnected.
➢
Replace or connect sensor
The appliance does not work.
(“FAULT” indicator is illuminated)
•
Condenser sensor defective or
disconnected.
➢
Replace or connect sensor
“WATER LOW” and “ICE FULL”
indicator flash together or
“FAULT” indicator flashes rapidly.
•
Refrigerant leakage.
•
Compressor does not run.
•
Ambient temperature is below
6 °C
➢
Check and refill.
➢
Check compressor.
➢
Keep ambient temperature
above 6 °C
“WATER LOW”, “ICE FULL” and
“FAULT” indicators all flash slowly.
•
HALL sensor defective or
positioned incorrectly
•
Paddle motor defective
➢
Replace or reposition sensor.
➢
Replace motor
“FAULT” indicator flashes rapidly
(after period of operation)
•
Ice turning motor damaged.
•
Micro-switches do not
function.
•
Water resevoir damaged.
•
Water resevoir bocked by ice.
➢
Replace motor.
➢
Replace or adjust switches.
➢
Replace water resevoir.
➢
Remove ice.
The “WATER LOW” indicator is
flashing.
•
The water supply is
interupted.
•
The water pressure is not
sufficient.
•
There is insufficient water in
the water resevoir
•
The water filter is blocked.
•
The water supply hose is
kinked/twisted.
➢
Check the water supply and
sealing ring.
➢
Check the water pressure. It
should be between 2 and 3
bar.
➢
Add water to the water
resevoir.
➢
Remove and clean the filter.
➢
Unkink/untwist the hose.
The “WATER LOW” indicator is
illuminated.
•
Appliance was without water
supply for more than 24 hours.
➢
Check water supply and restart
appliance.
The compressor does not work.
•
The ice storage bin is full.
•
The water supply is
insufficient.
➢
Remove ice from the bin.
➢
Check the water inlet.
➢
Clean or replace the sensor.
