Maxima 09500700, Руководство пользователя

Страница: 7 / 16

Spangenberg International B.V.
– Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
info@maximaholland.nl - www.maximaholland.com
Operation
•
Open the lid and fill the water tank up to the “MIN” mark.
•
Switch on the appliance using the “ON/OFF” switch located at the back.
•
Add your (sealed/packed) product to the tank. It is recommended to always use the cooking rack.
•
Make sure the water level is kept between the “MIN” & “MAX” mark at all time.
•
Close the lid and set temperature & time as desired.
•
Place the rubber insulating cover over the lid to help preserve heat and avoid injury.
•
After the preset time has ended the appliance will “beep” every 20 seconds until the “STOP” key is pressed.
If there is no action, the appliance will keep the water at the preset temperature.
•
Open the lid and lift up the rack to remove your product.
•
When not in use, switch off the machine using the “ ON/O FF” switch.
•
If the appliance will not be used for a longer period, please remove the plug from the main socket
•
Clean the appliance after use (see chapter “ Cleaning and Maintenance ”).
Troubleshooting
The follow overview will help you understand possible problems. However, only qualified
technicians should attempt to open or repair the machine. Contact your supplier when in doubt.
Problem Possible Cause Possible Solution
The appliance does not work.
(display off)
▪
The appliance is switched off.
▪
The power supply is
interupted.
▪
The voltage is not correct.
➢
Activate the appliance.
➢
Check the power supply, plug
in power cable.
➢
Use a compatible power
source.
The appliance has stopped
working.
▪
Overheat protection
activated.
➢
Let the appliance cool down
and reset using the reset
button at the back. Contact
your supplier!
The appliance is switched on but
does not get warm.
▪
Defective thermostat.
▪
Defective heating element.
➢
Replace part.
➢
Replace part.
The temperature cannot be set /
adjusted.
▪
Defective thermostat.
▪
Defective control panel.
➢
Replace part.
➢
Replace part.
E01: Low water.
▪
Not enough water in tank.
▪
Filters blocked or dirty.
➢
Add water.
➢
Unblock/clean filters.
E02: Set temperature could not be
achieved in set timeframe.
▪
Lid not closed properly.
▪
(cold) Water was added
during the program.
▪
Pump or heater defective.
➢
Lid not closed properly.
➢
Do not add water during
program.
➢
Replace part.