E
N
G
LI
S
H
7
OPERATION
1
Switch on the appliance by turning the "Thermostat Dial".
2
Set your desired temperature using the "Thermostat Dial". During the heating process the heating
indicator light will turn on.
The first time you use the appliance, there may be some smoke development and a slight odor
noticeable. This is normal and should disappear after a few times use.
3
When the heating indicator deactivates, the unit has reached the set temperature and is ready for use.
4
Before adding the batter, lightly coat the cooking plates with butter or cooking oil (non-stick baking
spay also works well). This will help avoid the waffle sticking to the cooking plates.
Repeat this process every few batches.
5
Add just enough batter to cover the peak areas, do not overfill.
6
Close the lid to and set the timer as desired. When the set time has passed, the timer will ding.
7
Check if the waffle is cooked properly and remove it using a wooden or plastic utensil.
Use caution when removing the waffles, as the waffle iron is very hot and can cause serious burns.
It is recommended to use protective gloves during handling.
8
When not in use, switch off the machine by turning the "Thermostat Dial".
9
Clean the appliance after use (see chapter "Cleaning and Maintenance").
10
If the appliance will not be used for a longer period, always switch off and disconnect the power supply.
TROUBLESHOOTING
The following overview will help you understand possible problems. However, only qualified technicians
should attempt to open or repair the machine. Contact your supplier when in doubt.
Problem
Possible Cause
Possible Solution
The appliance does not work.
(POWER indicator off)
]
The appliance is switched off.
]
The power supply is interrupted.
]
The voltage is not correct.
f
Activate the appliance.
f
Check / connect the power supply.
f
Use a compatible power source.
The appliance does not
get warm
(HEATING indicator on)
]
Low temperature settings.
]
Thermostat defective.
]
Heating element defective.
]
Overheat protection is activated.
f
Adjust temperature setting.
f
Replace part / contact supplier.
f
Replace part / contact supplier.
f
Reset temperature limiter.
Temperature cannot
be adjusted.
]
Thermostat defective.
f
Replace part / contact supplier.
Indicator light does not work
but appliance works normally.
]
Indicator light defective.
f
Replace part / contact supplier.