Page
11
of
18
ASSEMBLE THE PULL-
PULL CABLES AND
FLYING WIRES:
Assemble the clevis/cable
connector assemblies. Put
the clevis near the end of
the cable adaptor so that there is at least
1/4" of thread left behind the clevis.
Temporarily tighten the locking nut.
Install a clevis/cable end assembly onto
ONE end of each of the wire cables
provided.
1 - Feed the cable through the crimp
tube, then through the cable adapter,
then back through the crimp tube.
2 - Bend the cable around and feed it
through the crimp tube again from the
adapter end.
3 - Grab the end of the cable with a pair
of pliers and pull it tight .
4 - Use crimping pliers or dull wire
cutters to crimp the tube onto the cable
and then cut off the excess cable.
IMPORTANT: Put a drop of thin CA at each
end of the crimp tube to prevent slipping.
INSTALL THE ELEVATOR PULL-PULL
CABLES:
Install two micro servos in the
servo tray in the fuselage
using the mounting hardware
that came with your servos.
Locate the wire exit holes in
the sides of the fuselage.
There are two for the elevator
cables and one further back
for the rudder cable in each
side.
