Maxell MA-8610BK, Руководство пользователя

Страница: 9 / 61

English - 8 -
Connecting the IR Receiver
Before plugging the Display into the mains supply, connect the supplied IR receiver to the IR input on the
Display. Place the IR receiver in sight of your own remote control. Simply operate your remote control whilst
pointed at the IR receiver and it will relay the control signal to your Display.
In case your Display has touch screen feature and if the IR receiver is going to be placed on the Display it
shouldn’t be placed facing the inside of the screen, otherwise the signals of the touch screen and the remote
may interfere with each other. To improve the performance of your remote control place the IR receiver as
shown in the drawing below.
Front side of the Display
Turning the Display On/O ff
After connecting the Display to the mains set the main On/Off switch to the “1” position. The Display will switch
into standby mode. Press the Standby button on the remote or press the centre of the joystick in located on
the rear left side of the Display and hold it down for a few seconds to switch it on from standby.
Press the centre of the joystick in and hold it down for a few seconds or press the Standby button on the remote
to switch the Display into standby mode. To switch the Display off, set the On/Off switch to the “2” position.
2
3
Standby button
Joystick
On/Off Switch (*)
(*) The location of the On/Off switch may differ depending on the model.
LED Status Status of the monitor
Power LED not lit Power on
Power LED lit Power off (Standby mode)
Power LED flashing (slow) Scheduler active (optional)
Power LED flashing (fast) Software update