Maxcess Tidland Raptor Series, Руководство по эксплуатации и обслуживанию

Страница: 13 / 28

www.maxcessintl.com Tidland Raptor AP Chuck MI 660290 1 P Page 13 of 28
3" AIR POWERED LUG CHUCK
Replace Diaphragm
 Correct orientation of the folded diaphragm is essential for proper operation.
 It is not necessary to remove the lugs or actuator assembly to replace the diaphragm.
Removing
1. Remove adapter from chuck (page 25), if installed.
2. Remove chuck from machine and set on workbench, backplate facing up.
3. Use #10-32NF screws in the jacking threads to lift and remove the diaphragm retainer
ring.
4. Separate the diaphragm from the retainer ring and remove from the chuck.
5. Remove the diaphragm retainer plate.
Reinstalling
1. Ensure that the diaphragm is folded back on
itself so that the bead faces toward the inside.
Note: The diaphragm has a rough side (like a
cloth weave) and a smooth side. Install the
rough side against the piston.
2. Set the diaphragm on the actuator assembly.
Maintaining the fold, push the diaphragm
down around the actuator assembly in the
chuck body. Align the bolt holes.
3. Install the diaphragm retainer plate and align the bolt holes.
4. Apply a small amount of
LOCTITE 242 to the button head capscrew threads and install
them in 6 places.
5. Press the diaphragm "bead" into the groove all the way around diaphragm retainer ring.
6. Set the retainer ring down on the actuator assembly.
7. Install the o-ring.
O- RING
Note: If diaphragm edges are properly aligned in the retainer ring groove,
the ring seats almost completely in the chuck backplate. Complete
compression occurs when the chuck is reinstalled on the machine.
BEAD
DIAPHRAGM RETAINER RING
BOLTS (6 PLCS)
DIAPHRAGM RETAINER PLATE
DIAPHRAGM
O- RING
CHUCK BODY