Maxcess Tidland Performance Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 45 / 72

KNIFEHOLDER DISASSEMBLY AND MAINTENANCE
www.maxcessintl.com Tidland Performance Series Automatic Knifeholder MI 557417 1 AD Page 45
Upper Body, Lower Body, and Piston Assemblies
– Class II and III
Complete illustration: Class II and III, page 58
Required Tools
Class II .......................... 3 mm hex wrench
Class III ......................... 4 mm hex wrench
Parker Super O-Lube O-ring Lubricant
Lubriplate EMB Polymer Grease (L0148-098)
Disassembly
Class II and III
1. Disconnect air supply hose at the manifold.
2. Remove knifeholder from guide bar.
3. Remove blade cartridge from control body.
4. Place control body on workbench.
5. Remove dovetail assembly (p.41).
6. Remove guide bar mount assembly:
with pneumatic lock ...... p. 39
with manual lock ........... removal not required
7. Carefully remove the flange retainer and spring.
Caution! The flange retainer is under spring pressure. Hold the flange retainer firmly to the lower
body when removing the four fasteners.
8. Remove the four socket head cap screws that attach the upper and lower bodies to each other.
9. Lay control body flat on one side and carefully push (toward upper body) the piston guide rod into
and through the guide rod bushing. This allows simultaneous removal of both the upper body and
piston assemblies from the lower body.
Note: The Upper Body and Piston assemblies are connected by three internal coiled hoses. Be
careful not to disconnect, rupture or loosen these connections.
Upper Body and Piston disassembly is complete.
Recommended Maintenance

Lubricate piston guide rod with Lubriplate EMB Polymer Grease (L0148-098).

Inspect and replace the piston o-ring, if necessary. Lubricate* new o-ring before installing.

Inspect piston spring and return spring support and replace if excessively worn.

Lubricate* stroke stop rod.
*Use Parker Super O-Lube.
(Reassembly on next page.)