Instruction for Use
Instruction for Use
P.33
P.32
6Fixed Program P3
6.1 Press PROG. switch button six times to choose P3 running program when
treadmill is standby.
Press “+”or”-” to adjust running time after P3 display 3 seconds and ”30:00”
flashes on the operation display
Then press “+”or”-” to set time.
Treadmill will start after complete adjustment.
Time window shows time reciprocal, distance window shows running distance,
calorie window shows calorie to be consumed, and speed window shows the
speed in each segment.
Altogether 10 segments for this mode,
You can set the speed for each segment while the time is fixed.
6.2 Treadmill stops working when time window shows“0:00”
5
4
8
8
6
8
6
8
4
1
Photoelectric Heart Rate Monitoring
Put your hand over the sensor on the left of operation display when treadmill is
standby or at work,
Value on the operation display will automatically switch into your current heart
rate.
Notes:
The heart rate data will be different by the different way you hold the handrail.
The data is only for reference, not medical basis.
More details,please see appendix
Segment
Speed
km/h
1
2
3
4
5
6
7
8
9
10
7Error information of control device and troubleshooting methods
1. Information Code: Er 1, Safety key disconnected
1.1 Check whether the safety key is connected to the designated position.
1.2 Check whether the safety key is loosen or dropped
1.3 Check or replace the safety key
1.4 Check or replace the console
1.5Check or replace the controller circuit board
2. Information Code: Er 7, Problem on the motor near motor
2.1 Check if the motor cable is loosened or dropped.
2.2 Check or replace the motor.
2.3 Check or replace the controller
3. Information Code: Er 8, No signal error
3.1 Check if the connecting cable is loosen, dropped or damaged
3.2 Check or replace the console
3.3 Check or replace the controller
4. Information Code: Er 9, Overload protection
4.1 Check if overloaded
4.2 Check if the mechanical running parts are jammed
4.3Check if there is a lack of lubricant oil. When lack of lubricant oil, the friction
between plate and belt would increase
4.4 Check if the running plate is badly worn
4.5 Check if the running belt is badly worn
4.6 Check if the motor is short-circuited
4.7 Check or replace the controller
4.8 Check or replace the motor
5.Information Code: Er 10, Overvoltage/Undervoltage protection
5.1 Please check if the voltage on the power is normal: AC 220-240V
5.2 Check or replace the controller
5.3 Check or replace the motor
6.Information Code: Er 11,Over current protection
6.1 Check if overloaded
6.2 Check if the mechanical running parts are jammed
6.3 Check if there is a lack of lubricant oil. When lack of lubricant oil, the friction
between plate and belt would increase
6.4 Check if the running plate is badly worn
6.5 Check if the running belt is badly worn
6.6 Check if the motor is severely short-circuited
6.7 Check or replace the controller
6.8 Check or replace the motor
Содержание CYBER RUN
Страница 1: ...產品使用說明書 MAX X04XQSR01 Instruction ...
