Maxcare CYBER RUN, Инструкция по эксплуатации

Страница: 11 / 11

Maintenance Guideline and Instruction Maintenance Guideline and Instruction
P.36 P.37
3. The procedure to squeeze silicone oil on the running plate:
a) As shown in the picture, cut the oil bottle pipe, twist off the cover, tear the
inner sealing paper, and then tighten the cover.
b) When the running machine is stop working, squeeze the oil bottle slowly to
let the oil flow into the running belt through the oil pipe, and run the treadmill at
a speed of 1km/h to evenly apply the silicone oil, and lightly tap on the belt in
the middle. In a few minutes, the silicone oil can be completely absorbed by the
running belt.
2.2 Tautness adjustment of the running belt.
The running belt has been adjusted to a suitable tautness twice after the
installation and before delivery. However, after use for a period of time, the
running belt could be somehow loose. For example: the user may feel standstill
or slippery during his running. When this phenomenon occurs, please adjust
the tautness of the running belt by rotating the both left and right adjusting bolts
clockwise with a half circle as a unit. (to tighten the running belt, please operate
in an anticlockwise direction). If the running belt is too loose, the user will feel
slippery when running; while it is also not good if the running belt is too tight,
because it shall increase the motor load and damage the motor, running belt,
the roller and etc.
2.3 The belt centering
1. Place the running machine on even ground.
2. Start the running machine and set the speed at about 3.5 kilometers per
hour.
3.If the running belt is tilted to the left side, rotate the adjustment bolt on the left
side by 1/2 circle in the clockwise direction , and then rotate the adjustment bolt
on the right side by 1/2 circle in an anticlockwise direction.
4.If the running belt is tilted to the right side, rotate the adjustment bolt on the
right side by 1/2 circle in the clockwise direction , and then rotate the
adjustment bolt on the left side by 1/2 circle in an anticlockwise direction.
If the running belt is tilted to the left
side, rotate the adjusting bolt as
image
If the running belt is tilted to the
right side, rotate the adjusting bolt
as image
Note: The cut is about 5 mm
2.4 Driving belt adjustment
The driving belt has to be adjusted before delivery. However, after using a
period of time, slipping phenomenon may occur and the user can adjust the
driving belt by itself.
Adjustment procedure (as shown in the right picture):
①
Rotate the adjustment bolt clockwise with a wrench
②
The adjustment range: take load without slipping as the standard
Note: please clean junk in the belt groove and pulley groove regularl
Please contact your local distributors for service.