P/N 07623093 Rev A Page 3
2281PR-100
Single Hood
User Instructions
7. If Hood Filter is wrinkled in front, use one hand to secure the Hood at the Lens
bottom (either from under the Hood as shown, or from the outside of the Hood) and
use the other hand to grasp the Shroud just below the Filter in back and pull down
until all folds in the filter are removed. Ensure the Hood is down, all around.
6. Grasp the back bottom Hood Shroud (either from
the inside of the Hood as shown, or from the
outside of the Hood) and pull the Hood over the
Helmet and down in back.
8. With the Hood front Shroud down, the
NecktTie and its Size-Snaps indicate
three settings for wearer neck sizes;
Neck diameters of 13-15 in., 16-17 in,
and 18-19.5 in.
9. Pull the NeckTie ends
around to back by briskly
and quickly pulling the
ends free from their
velcro clasp.
10. Snap the left NeckTie
end Snap to the
appropriate Size-Snap on
the right Necktie end.
11. The Hood should be
secure within about an
inch of the neck to
ensure a good fit and
allow complete freedom
of head movement.
Doff the Hood and Helmet
1. Roll up Hood from Shroud back bottom up and
over to top front of Helmet.
3. Slide Front Lens mounting hole back over Helmet front adapter
and lift lens and Hood fully away from Helmet.
Continue to roll Hood inside-over-outside until Hood is fully away
from body, and discard appropriately for contaminated waste.
2. Lift out and unsnap each side Lens slot bottom
and then lift Lens sides up and off Helmet.
4. Loosen the rear Headband
Adjustment Knob (turn
counterclockwise).
5. Lift Helmet up and off
head.
