P/N 08023027 Rev B Page 3
2272PB-100
Double Hood
User Instructions
15. Place back of outer Shroud over Helmet and don
outer gown per gown manufacturer’s protocol.
Place inner Shroud inside outer gown and close
gown. Pull outer shroud down all around gown.
16. Pull Neck ties loose from behind, pull them around in front and tie securely, within
approximately one-half inch of the neck.
Similarly, loosen body ties and pull them around and through the slots in the lower
front outer shroud, and tie securely.
Don the Optional HFR FCC (High Fluid Resistance Filter Cover Cap)
Doff the Optional HFR FCC (High Fluid Resistance Filter Cover Cap)
3. Hold the underneath back of the
Helmet steady with the thumb while
pulling the back of the HFR FCC fully
down to even with the bottom rear of
the Helmet.
2. Pull HFR FCC over and down in
back to cover the entire Hood
Filter.
1. Align the front centerline of the HFR
FCC with the front centerline of the
Hood and position the HFR FCC
over the Hood so that both front
bottoms align.
3. Continue lifting until the HFR FCC is
completely clear of the Helmet; de-
con appropriately for next use.
2. Continue to lift the HFR FCC
rear up and off the Hood/
Helmet.
1. Holding the front of the HFR FCC
steady, push up its rear to begin
lifting it up and off the Helmet.
