Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Page 4 01023577 Rev B
2260-05 DLC Shroud
Instruction For Use
WARNING
Refer to Users Instructions
(P/N 03521015) for details on
chargers and charging batteries.
10. Pull neck ties around to the
front and tie securely, leaving
about a ½ inch gap between
neck and Shroud. Pull waist
ties around and tie in front.
8. Continue pulling Shroud down all around.
Doffing
9. Don outer body gown
under the shoud per
gown manufacturer’s
instructions.
3. Continue rolling while bringing
shroud to front, pulling Lens off the
Helmet. Continue pulling foward
away from the body and discard.
2. While pulling up the shroud
from the bottom back, roll the
shroud inside-over-outside, up
and over the Helmet.
1. Untie all ties.
4. Remove other PPE
per manufacturers’
recommendations.
7. Lift Helmet up,
foreward, and off the
head.
6. Loosen Ratchet Knob
(counterclockwise).
8. Disconnect Power Cord from
the Battery - push Secure
Connection Button down,
pull Cord Connector out,
release the Button.
9. Disconnect the Battery Belt
from around the waist by un-
snapping the buckle.
10. Connect Charger to mains wall power,
connect the Charger Cord to the Battery.
Push the Charger Cord Connector into the
Battery Receptacle until it is fully seated.
The entire CAPR System may be
decontaminated, cleaned and/
or stored at this time.
5. Discard all
disposables per
institutional
protocal for
contaminated
waste.
