© 2017 - MaxAir Trampolines, LLC
Document May Not Be Reproduced Without the Consent of MaxAir Trampolines, LLC
Page 8
7’ x 14’ flfLybed tramp
These plans are for reference ONLY and are not the technical installation plans
11.
Cover landscaping fabric with crushed stone to a depth of 2-3”. Stone should cover the entire pit floor
including bottom 2-3” of tapered retainer wall.
12.
Place all 12 metal frame pieces in position on the top surface of your landscaping ties. Each side will
consist of three frame pieces
13.
Make sure all frame pieces are butted up to, and touching each other. Some pits don’t end up being perfectly
square, and dimensions may vary by an inch or two. Due to this, we recommend aligning the frame pieces
so that the gap from the corners, to the frame edges are the same distance at each end (use measuring
tape). This way, even if the lengths of your opposite walls are slightly different, your frame will still be centered.
14.
On each of the 2 ends and the 2 sides, once the 3 frame sections are aligned, first bolt down the middle tabs
of all 4 middle sections, using 7” x 1/2” lag bolts. Next proceed to bolt down all of the rest of the tabs.
15.
Starting at one of the short ends of the trampoline bed, you will see a smaller clip in each of the corners.
Attach a corner spring to the small clip and then attach to the frame. Working clockwise around the frame,
repeat for all four corners. Trampoline bed is now in position, and ready for remaining springs installation.
16.
Again, starting at one of the corners, attach two more corner springs to the remaining 2 corner clips
and then attach each spring to the frame. Working clockwise around the frame, repeat for all four corners.
When finished with this step, each corner will have 2 parallel corner-springs connected to the end frame,
and 1 corner-spring connected to side frame. (See corner-springs diagram on page 10)
17.
Attach the remaining springs one at a time, first to the short ends of bed and frame, spaced 5-1/4” from
corner springs and from each other, alternating ends after installing each spring, until you have attached all
springs to both ends. Repeat, for long sides of trampoline. 10 springs will remain.
18.
Use 4 of the remaining springs, attach one diagonally in each corner, from wiggle wire to wiggle wire.
(See bottom right corner of diagram on page 10)
19.
Install pads over trampoline springs and frame. Depending on the pads ordered (Standard, Premium,
or Deluxe), the method of attachment will vary. Follow pad installation instructions on pages 13 - 15
Disclaimer: Remember to follow proper trampolining protocols to ensure your safety. For flipping and
somersaulting skills, please consult a trained professional.
INSTALLATION INSTRUCTIONS
