4
Maxa Technologies Ltd
MT-200E WIFI manual
Ver1.1
Please note WPA-PSK authentication is available with TKIP only and WPA2-PSK with AES. Please
configure your router accordingly!
-
Then test the printer if settings have been stored, by performing ‘SelfTest’ print – when
printer is turned off, hold feed button and turn printer on, after few seconds printer
configuration will be printed.
-
If you configured DHCP, IP configuration can be printed by pressing reset button for 1
sec located on back of Wi-Fi card
-
Holding reset button for more than 5 seconds, returns Wi-Fi card settings to default
configuration:
IP:
192.168.0.254
Subnet
255.255.255.0
Gateway
192.168.0.1
Printer communication in Infrastructure mode
Network communication can be direct or using Windows driver.
Windows Printer Driver 4.30
1.
When driver is installed – it needs to be installed in the same network, in our case
infrastructure network. During installation you will be asked to enter printer IP address:
IP address can be changed anytime in Printer Properties under Ports tab/Configure port
