Max RB215, Руководство по эксплуатации и техническому обслуживанию, Страница: 15 / 22

Arm
If the window is dirty and the pipe position can not be confirmed
Open the window and wipe off the dirty on the inside of the window with a soft cloth,
etc. Close the window again after cleaning to ensure that foreign objects will not be
able to enter the machine.
⑥
Keep inserting the Tie-Wire into the pipe until the tip of the wire comes out from the
Arm part within 5 mm (1/4”) or the wire hits the dead end.
⑦
Release the release stopper, and confirm that the release lever has returned to its
original position and that the feeding gears are clamping the Tie-Wire. This
completes the Tie-Wire mounting operation.
Tie-Wire
Release stopper
Feeding gears
Release lever
Tie-Wire
⑧
Remove the tape from the tie-wire completely.
⑨
Remove slack from wire spool.
Make sure the Tie-Wire does not get caught behind the wire spool. This could lead
to jamming.
●
When setting the main switch to ON, absolutely do not bring your fingers
close to the binding part and rotating part of the tip.
●
Do not switch the main switch ON and OFF in rapid succession, since this
operation will cause machine breakdowns.
●
Do not touch the Tie-Wire during the binding work (while the machine is
operating).
⑩
Mount the battery pack on the tool’s main body until a click is heard. Turn the Main
Switch on. Tool feeds the wire about 50 mm (2”) RB215, RB395, 100 mm (4”)
RB515 and cuts the wire automatically. Remove the cut end of the wire with pliers.
⑪
Unlock the Trigger before using the tool.
Trigger lock
Trigger
15