12
Hammer
Punch
r
Remove the pins jamming inside the nose or contact nose using the punch or a
regular screwdriver.
t
Set the pins properly onto the feed pawl again and close the door.
Regular screwdriver
HOW TO REMOVE JAMMING OF PINS
When removing jamming of pins, be sure to lock the trigger prior to disconnecting
the air hose.
PROCEDURE
q
Lock the trigger and disconnect the air hose.
w
Remove the pins out of the magazine.
e
Open the door, put a punch through the discharge outlet and hit it with a hammer.
WARNING:
APPLICATIONS AND PINS SELECTION CRITERIA
The tool is applicable to the following purposes. When using it, select the pins/nails and leg length suitable for the driving object.
Application
Type
Size (Leg Length)
Securing a thin steel plate to the
concrete
Ex.: Securing partition tracks
When using, allow for the nature
of the work piece and the
conditions at the job site to
comply with the Construction
Standards.
Plastic Coil Pins
Select the pins so that a penetration amount
into the concrete will be enough.
Approx. 7/8” to 1” (approx. 20 to 25mm)
Use of nails to secure the
thin steel plate to the
concrete causes them to
recoil or bend, endangering
you. Be sure to use pins to
secure it to the concrete.
CAUTION:
CAUTION:
Thin Steel Plate
Penetration Amount into
Concrete
