1.
Please install the tail plane as shown in the diagram below using an appropriate glue. Try not to use
too much glue as this can effect the balance of the model. (UHU Por, 2 Part Epoxy or Cyno)
2.
Install the plastic control horns to the control surface using the supplied screws. You will need to
use 2 screws per control horn. The screws are put through the horn from the connector side. There are
four holes in each horn, be sure to put one screw at the front and the other at the back diagonally as per
the picture below.
3.
The plastic snap connectors on the end of the control rods can now be adjusted for length and
connected to the control horns. At this stage try to make sure the control surfaces are straight and in
alignment.
4.
The wing has the aileron servo pre installed, you will need to connect the aileron servos wire to the
receiver in the fuselage. Please make sure that the plug is inserted in the correct way, the colours should
line up with the other leads already installed.
5.
Place the wing on to the fuselage slightly forward of its final position and then slide it backwards
into position, when aligned you can hold it in place with the 2 supplied wing bolts.
6.
The tricycle undercarriage pushes in to place as per the diagram below. Please be sure to install
the front wheel the correct way.
7.
It is a good idea at this stage to remove the battery hatch which is located between the wheels and
held in place with magnets.
