Maverick Campers Operations Manual 2021
S E T T I N G U P Y O U R H Y B R I D
Depending on which Hybrid model you purchased, the setup process will slightly vary.
For instance, the Viper 16 setup doesn’t require the rear fold out of the bed section where as all other models of Hybrids
do require this process.
The general process of setting up a hybrid is as follows;
Step 1: Lower the stabilizer legs
Included with your Maverick Camper Hybrd is a winder for manually winding down your stabilizer legs. All Hybrids have
a stabilizer leg on each of the 4 corners.
To lower and set you stabilisers legs undertaking the following process
-
Pull the blue handle of the stabiliser leg to unlock the leg
-
Be careful as the leg will swing once unlocked
-
release the blue handle once the stabiliser leg is in the downward position
-
Please note on uneven surfaces you stabiliser leg may not be vertical but slight off vertical to accommodate the
uneven terrain
-
Commence winding the stabiliser down using the winder provided
-
Ensure that the stabiliser is firmly touching the ground to prevent movement when inside the trailer but not so
firm that it puts the stabilser at risk of breaking or failing
-
Repeat this process on the remaining stabilser legs
-
If you still feel bounce when moving around the camper trailer, try to identify which stabiliser leg is not firmly
touching the ground and extend until the bounce goes away
Step 2: Open the Main Door
During travel the main door should be locked and closed. To open it, use the provided key to unlock it and then use the
lever to open it. Some models require the level to be lifted up or down before turning the key to unlock it.
To separate the safety fly screen from the main door, locate the latch on the inside of the door as per below image
shows:
Содержание CAMPERS
Страница 72: ...Maverick Campers Operations Manual 2021...