Maverick Campers Operations Manual 2021
-
Open the gas cylinder tap to release the flow of gas.
-
Test the water is flowing through the faucet of the kitchen and test the stove is igniting and staying alight.
-
Pull out the additional benches for chopping etc as required.
-
The kitchen is now ready for use.
Step 7: Attaching the Annex
-
Identify the walls and floors and separate the two
-
To attach the walls, the process is the same as the annex, you zip the wall to the annex and then ensure the
Velcro sections attach to create a strong, water and wind tight seal
-
Once all walls are on, ensure you also attached the trailer skirt which attaches either by Velcro or studs. The
skirt ensures that wind does not flow under the trailer into the annex and completes the enclosure walls
-
Finally attach the floor by way or Velcro and the job is complete
P A C K I N G D O W N Y O U R C A M P E R T R A I L E R
The process of pack down is the opposite of the setup however there are some critical points to note so that this process
is made as easy as possible.
-
Separate and pack down the annex and awning first. Some customers have mentioned to us that they leave the
annex attached and pack it in with the main tent. Whilst this is not recommended by us as it can put added
pressure on locking clips and bows, this is a decision you can make for yourself however please note, any
damage caused by this is not covered by our warranty.
-
Make sure you move the cushions and table into their travel position before packing down, this means the table
is folded and stored in the groove just below the seating cushions and the back rest cushions are laying flat
across the folded table.
-
Fold the bow pole down nearest the end of the trailer. The bow is gas strutted but will stay down once folded
down
-
Prior to folding over the bed section of the trailer, you can assist with the packing process by looping the
mattress holding straps around the gas strutted bow to ensure it stays down during the folding process
-
Whilst pushing the bed section over, continue to check around the entire trailer for pinched canvas. This is a
common issue that you need to avoid to ensure you don’t damage the canvas. This is just a matter of constantly
pushing canvas into the centre of the trailer as you lower.
-
To lock the roof of the trailer into place. Start at the rear and using body weight, pull the top of the roof down
to the body of the trailer and using the locking clamps to hold it in place.
-
Once the rear left and right side locking claps are engaged move towards the front of the trailer locking the
clamps into place along the way. You will notice these clamps are much easier to lock that the rear end ones
due to the roof now being firmly in the closed position
-
If you find you can close the roof, try the following:
o
Check no canvas is pinching on all four sides
o
Check the bow poles are folded down sufficiently
o
Check there are no obstructions inside the camper such as poorly packed items or table or cushions
preventing the proper closure
-
Once secure, the boat rack can now be folded over and secured into position
-
Always check that all gas, water, electrical and other non-permanent connections are turned off and are
disconnected
Содержание CAMPERS
Страница 72: ...Maverick Campers Operations Manual 2021...
