9. ATTACHING THE LIGHT
KIT
(Optional)
1. Remove the switch
housing
cover from the
switch
housing.
Remove
the
plug from
the
switch housing cover, attach the light kit to the
switch housing cover by feeding the light kit
wires (black and white)
through the hole of
switch housing cover and then screw it onto the
switch
housing cover by nut
&
lock washer
provided. Be sure it is tight enough to prevent
light kit from vibrating loose. (Fig. 16)
Nut
Plug
-.IS
~,
..•......
_---_
...
Lock washer
_Switch
housing
cover
2. While holding the light kit under your fan, locate
two single white and blue wires in the switch
housing
labeled
"FOR
LIGHT".
Make
the
polarized plug connections: (Fig. 17)
- White to white
- Blue to black
3. Carefully push all wires back into the switch
housing. Attach the light kit fitter by aligning its
keyhole slots with the three screw holes and the
reverse
switch
on
the
side
of
the
switch
housing. Tighten the three screws securely to
prevent the light kit from vibrating loose.
4. Install CFL bulbs (not included).
5. Remove the rubber washer, metal nut, light cap
and decorative nut from the light kit. Place glass
shade over the light kit stem, secure with the
rubber
washer,
metal
nut,
light
cap
and
decorative nut. Do not overtighten.
6. Restore power and your light kit is ready for
operation.
NOTE:
Make sure to leave enough space between
the fan pull chain and the bulbs so the chain
doesn't rub against any of the bulbs.
9
Figure 16
Ligh! kit
-+
0 .••....
~+-
Bulbs
assembly
Glass shade
-+
Figure 17
