Matsui MS452S, Инструкция по эксплуатации, Страница: 8 / 21

5
If all the lights are blinking, this means the machine is out of order. Please turn off the dishwasher, disconnect it from the power
supply and disconnect it from the water inlet. Call a qualified technician.
4
5
6
7
8
Press the ON/OFF button.
Press the button to start the washing.
Start/Reset
Press ON/OFF button again to turn off th e dis hwa sher
when the was h cy cle is com pleted.
Insert the plug into the socket.
The power supply is 220-240VAC 50Hz. Make sure that
the water supply is turned on to full pressure.
The control panel shows the status of the dish wash er.
a) All the p rogram lights are of f means the unit is on stand by
mode.
b) Program light is not blinking means the un it is on pau se.
c) Program ligh t is blinking means the unit is running.
To chang e the programme if the washing cyc le has already
star ted, pleas e follow the steps be low.
NOTE: If you open the dishwasher's door during the washing
cycle and then close it, the dishwasher will continue the
current washing programme after 10 seconds. However, if the
door is not closed correctly after 1 m inute, the dishwasher will
make an audible sound at 1 minute intervals.
Pots, plates, glasses and
lightly soiled pans.
Normally soiled.
Pre-wash
-wash
Wash (47 ℃ )
Rinse (70 ℃ )
Drying
Pre
Pots, plates, casserole dishes.
Dishes that have been sitting
with dried food on them for
awhile.
Plates. glasses, and bowls.
Lightly soiled.
Normal
Strong
Economy
Main wash(20 g)
Pre-wash
-wash( 0 ℃
Wash (50 ℃ )
Rinse
Rinse (70 ℃ )
Drying
Pre 5 )
Wash (40 ℃ )
Rinse (60 ℃ )
Drying
Wash (45 ℃ )
Rinse (70 )
Drying
℃
N ormal Wash
(EN 50242)
For dishes that need to be
rinsed and dried only.
Rinse
To rinse dishes that you plan
to wash later that day.
Soak
Pre-wa sh
A shorter wash for lightly
soiled loads that do not
need drying. Ra pid
Wash (40 ℃ )
Rinse (55 ℃ )
Rinse
Pre-wash(4 g)
Main wash(20 g)
Pre-wash(4 g)
Main wash(20 g)
Main wash(15 g)
Main wash(15 g)
X
X
1
Pull out the lower and upper racks, load the dishes and
push the racks back. It is recommended loading the lower
rack first, then the upper one.
3
Make sure the door is properly closed.
Pour in the detergent (see the sections for Salt, Deterg ent
and Rinse Aid ).
Select your desired washing program by turning the dial
to the respective washing cycle.
2
1. Open the door slightly to check if the unit has dispensed
the detergent or detergent tablet. This will depend on how
long the washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you
to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press
Start/Reset button for more than 3 seconds. This will cancel
the current programme.
4. Close the dishwasher door and re-select the washing
program by turning the program dial.
5. Press Start/Reset button again to start washing.
X