Matsui MS452S, Инструкция по эксплуатации, Страница: 6 / 21

3
Make sure your plumbing is suitable to install
with the new dishwasher. If in doubt contact a
qualified plumber.
The water pressure coming from the water
mains supply need to be at a m inimum of 0.4
and to maximum of 10 bars.
max 10 0 cm
min 40 cm
min 4cm
Fit the drainage hose of your machine
to the drainage pipe without bending.
washing process.
Secure your hose firmly to the waste
pipe to avoid it coming off during the
drainage system.
The waste pipe must only be connected
into the foul drains and not surface water
First connect water inlet hose to your
dishwasher as Ensure black rubber seal is
in place.
Then connect the straight end to your water
mains supply as
Ensure black rubber seal is
in place.
Turn on the tap and check for leakages after
connecting the hose.
Please ensure the tap is turned off when the
machine is not used.
If you only have cold water mains:
The Y adaptor can be used to
provide you with the additional
cold water feed you need for the
dishwasher. Y adaptor is available
from most DIY stores.
The hose should be placed between
40 cm and 100 cm from the floor level
and m ust not be extended otherwise the
machine m ay not be able too expel the
waste water properly.