
8
INSTALLATION
GB
• Secure the water drain hose to the waste pipe to
avoid it coming off during the washing process.
8. Make sure your plumbing is suitable for use with the
dishwasher. If in doubt contact a qualified plumber.
This unit MUST BE connected to COLD WATER MAINS
using the new water inlet hose. OLD HOSE SETS
MUST NOT BE RE-USED. The water pressure from the
water mains needs to be at a minimum of 0.04 MPa
and a maximum of 1.00MPa.
• Connect one end with aqua stop of the safety
water supply hose to your dishwasher, and then
connect the other end of the hose to your water
mains. Please ensure the black rubber seal is in
place.
• After connecting the hose, turn on your water
mains and check for leaks.
• Connect the dishwasher to the mains socket.
You may use a Y-adaptor (not
included) for an additional water
feed for another appliance, for
example a washing machine. This
is only applicable for cold water
mains. A Y-adaptor is available
from most DIY stores.
About the Safety Supply Hose
The safety supply hose consists of the double
walls. The hose’s system guarantees its
intervention by blocking the flow of water in
case of the supply hose breaking and when
the air space between the supply hose itself
and the outer corrugated hose is full of water.
• The waste pipe must only be connected
to the foul drains and not the surface
water drainage system.
• The water drain hose should be placed
lower than 10cm from the table top and
must not be extended, otherwise the
unit may not be able to expel the waste
water properly.
• You may use the u-shaped drain hose
holder to secure your drain hose and to
avoid bending it.
• Do not bend your drain hose.
• Do not lift the drain hose higher than 10 cm from
the table top, otherwise the unit may not be able
to expel the waste water properly.
water mains
Y-Adaptor
(not included)
Connect
to another
appliance if
required.
water supply hose
max.
10cm
Please close the hydrant after using.