d. Once the charged light comes on, device can be
disconnected from the Switching Power Charger.
Note: You can press the TEST button to check power level.
OPERATING INSTRUCTIONS
USE AS A BATTERY CHARGER
The portable power source can be used to restore a limited
charge to the vehicle battery.
1. Using the DC extension cord included with the portable
power source, plug one end into the portable power source.
Plug the other end into the vehicle cigarette outlet. Allow
the battery to charge for 30 minutes.
2. Some vehicle ignitions must be turned to accessory to
activate the cigar lighter socket. A defective battery may
not accept a charge from the portable power source.
3. Remove the power extension cord and start the vehicle.
USE AS A JUMP STARTER IN EMERGENCIES
For optimum performance, do not store below 10°C when using
as a jump starter. The portable power source will only jump
start a battery if there is more than 3 volt DC of power
remaining in the battery. If the battery is below 3 volt DC,
please refer to, “Operating Instructions: Use as a battery
charger”, and follow the instructions to recharge the battery.
1. Ignition MUST be turned off before making cable
connections.
2. Be sure you operate the portable power source in a well
ventilated area.
3. Be sure eyes are appropriately protected with safety
eyewear.
4. Attach the red (po) clamp to the positive terminal on
the battery.
5. Attach the black (negative -) clamp to the vehicle frame.
6. Be sure that all cables are clear of moving belts or fan
blades.
7. Keep a safe distance from battery while jump starting.
8. Turn on the vehicle ignition. If the vehicle does not
start after 6 seconds, let the portable power source
cool for 3 minutes before attempting to start the
vehicle again. Damage could result to the unit if this
is not done.
9. After the vehicle has started, disconnect the black (negative
-) clamp from the vehicle frame. Then remove the red