!
38
CPU / System
Temperature
Use these items to monitor the threshold
temperature for the CPU and system.
FAN Speeds,
voltages & Vcore
Use these items to monitor the parameters for
the fan speeds and the mainboard voltages.
Change Supervisor Password
If you highlight this item and press Enter, a dialog box appears
which lets you enter a Supervisor password. You can enter no more
than six letters or numbers. Press Enter after you have typed in the
password. A second dialog box asks you to retype the password for
confirmation. Press Enter after you have retyped it correctly. The
password is required at boot time, or when the user enters the setup
utility.
Change or Remove the Password
Highlight this item and type in the current password. At the next
dialog box, type in the new password, or just press Enter to disable
password protection.
Auto-Detect Hard Disks
This item automatically detects and installs any hard disk drives
installed on the primary and secondary IDE channel. Most modern
drives can be detected. If you are using a very old drive that can’t
be detected, you can install it manually.
Setup will check for two devices on the primary IDE channel and
then two devices on the secondary IDE channel. At each device,
the system will flash an N in the dialog box. Press Enter to skip
the device and proceed to the next device. Press Y, then Enter to
tell the system to auto-detect the device.
Save Settings and Exit
Highlight this item and press Enter to save the changes that you
have made in the setup utility and exit the setup program. When
