OPERATING INSTRUCTIONS
USE AS A BATTERY CHARGER
The portable power source can be used to restore a limited charge to the
vehcile battery.
1. Using the DC extension cord included with the portable power source, plug
one end into the portable power source.
Plug the other end into the vehcile cigarette outlet. Allow the battery to
charge for 30 minutes.
2. Some vehicle ignitions must be turned to accessory to activate the cigarette
lighter socket. Adefective battery may not accept a charge from the
portable power source.
3. Remove the port extension cord and start the vehicle.
USE AS A JUMP STARTER IN EMERGENCIES
For optimum performance, do not store below 10
o
C when using as a jump
starter. The portable power source will only jump start a battery if there is
more than 3 volt DC of power remaining in the battery. If the battery is below 3
volt DC, please refer to “Operating Instructions: Use as a battery charger”, and
follow the instructions to recharge the battery.
1. Ignition MUST be turned off before making cable connection.
2. Be sure you operate the portable power source in a well ventilated area.
3. Be sure eyes are appropriately protected with safety eyewear.
4. Attach the red (po) clamp to the positive terminal on the battery.
5. Attach the black (negative -) clamp to the vehicle frame.
6. Be sure that all cables clear of moving belts or fan blades.
7. Keep a safe distance from battery while jump starting.
8. Turn on the vehicle ignition. If the vehicle does not start after 6 seconds,
let the portable power source cool for 3 minutes before attempting to
start the vehicle again. Damage could result to the unit if this is not done.
9. After the vehicle has started, disconnect the black (negative -) clamp from
the vehicle frame. Then remove the red (po) from the battery
terminal. The yellow Charging light will remain lit until the red (po)
cable is disconnected from the battery. After use, store the clamps in the
compartments.
