Matrox DigiSuite LE, Руководство по установке, Страница: 27 / 140

15
Install non-DigiSuite cards first!
2
Refer to the label on DigiSuite LE to locate the digital module
connector (SDI connector). Then carefully align the SDI connector on
the digital module with the female connector on the DigiSuite LE card.
The four plastic pins on the digital module should be aligned with the
four holes in the DigiSuite LE card. Snap the module in place as
indicated on the label. To ensure that all pins on the SDI connector are
firmly seated in the female connector on DigiSuite LE, hold the digital
module-DigiSuite LE unit between your thumb and fingers and apply
pressure evenly along the SDI connector.
Warning The digital module internal cable should remain connected
to the module at all times. Do not try to remove the internal cable from
the digital module or tamper with the audio and video connectors on
the module.
Install non-DigiSuite cards first!
It’s important to install any non-DigiSuite cards in your system before
installing your DigiSuite cards. If you don’t do so, your DigiSuite system
may not work properly.
In addition, try to leave empty slots between your DigiSuite card sets and
non-DigiSuite cards if it’s possible. This will permit additional air flow
between cards. For more details on providing adequate ventilation, see
“Plan for adequate ventilation” on page 12 .
Adding DigiSuite cards to your system
If you’re installing multiple DigiSuite cards, skip ahead to “Determine
your DigiSuite card set order” on page 17 .
If, in the future, you add additional DigiSuite cards to your system, you'll
be installing an appropriate Movie-2 bus connector. Please read carefully
the section entitled
“Take care of your Movie-2 bus—Important!” on
page 18.