Matrix T130 X, Руководство пользователя

Страница: 16 / 24

16
BEFORE YOU BEGIN
LOCATION OF THE TREADMILL
Place the equipment on a level and stable surface away from direct sunlight. The intense UV light
can cause discoloration on the plastics. Locate the equipment in an area with cool temperatures
and low humidity. Please leave a clear zone behind the treadmill that is at least the width of the
treadmill and at least 79” (2 meters) long. This zone must be clear of any obstruction and provide
the user a clear exit path from the machine. For ease of access, there should be an accessible space
on both sides of the treadmill of at least 24” (0.6 meters) to allow a user access to the treadmill
from either side. Do not place the treadmill in any area that will block any vent or air openings.
The treadmill should not be located in a garage, covered patio, near water or outdoors.
LEVELING THE TREADMILL
Use of shim or adding leveling foot.
NOTE: It is extremely important that the levelers are correctly adjusted for proper operation. An
unbalanced unit may cause belt misalignment or other issues. Use of a level is recommended.
Remove the leveling shim provided on the underside of the treadmill. The shim can be found
mounted on the underside of the right hand side rail. Remove the rear foot on the side of the
treadmill that is resting low. Install the shim as shown above and return the rear foot.
When installing the optional rear leveling foot accessory, remove the existing rear foot. Replace with
new leveling foot and fasten to the frame using the existing fasteners that held in the half-moon foot.
WARNING!
Our equipment is heavy, use care and additional help if necessary when moving.
Failure to follow these instructions could result in injury.
POWER
This treadmill is powered by a power supply and must be plugged into a power jack. The
power jack is located at the front of the treadmill underneath the motor cover. Make sure
the power switch is in the ON position. Unplug power chord when not in use.
WARNING!
Never operate equipment if it has a damaged cord or plug, if it is not working properly, if it has been
damaged, or immersed in water. Contact Customer Tech Support for examination and repair.
0.6
m
(2
ft
)
0.6
m
(2
ft
)
2
m
(79”)
0.3
m
(1
ft
)
ENGLISH