www.szmatrix.com
14
4.6
Introduction to Initialization Function
Long press the "output switch/menu function button" to turn on, the power supply will perform factory
initialization of the "function menu", the power supply will beep after the initialization is successful, the settings
after initialization are as follows:
1. The power-on parameter remains set to ON: P-ST ON
2. The output status is set to OFF when the power is on: P-UP OFF
3. Set the buzzer sound to ON: BEEP ON
4. Remote compensation is set to OFF: SENSE OFF
5. The lower limit of voltage is set to the minimum value: VOL-L 0.000
6. The voltage upper limit is set to the maximum value: VOL-H 31.00
7. Set the current lower limit to the minimum value: CUR-L 0.000
8. The current upper limit is set to the maximum value: CUR-H 10.100
9. Communication address set to 1：SE8 ADDR 001
10. Communication baund rate set to 9600：SE9 BAUD 9600
11. Communication protocol choose:SCPI：SE10 PLC SCPI
12. The end of the protocol communication protocol is selected as LF：SE11 CEND LF
Remark:
The initial setting value of the upper limit of voltage and current varies slightly depending on the model. After
initialization, it is the maximum rated value of this model.
