Matrix MHG101, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 24

7
Gas burners
Gas flow to the burners is controlled by the control knobs (5,6,7 and
8 on Fig.1). There are 3 positions shown on the control panel (Fig.2).
Turning the control knob to the positions shown below achieves the
following:
Closed (switches gas valve and burner off)
Maximum position (highest heat level) & ignition position
Minimum position (lowest heat level)
The knobs should always be turned in an anticlockwise direction from
the closed/off position. Attempting to ignite the burner in a clockwise
direction from the closed position may cause damage to the hob.
Igniting the gas burners
This hob’s burners are fitted with flame failure devices. These operate
by shutting off the gas supply to the burner in the event that the flame
is extinguished whilst the control knob is in an open position.
To ignite the burners
Press the control knob down and turn the knob anticlockwise to the
maximum position (Fig. 3). Hold the control knob down to begin the
ignition process (a constant clicking should be heard). Once the flame
appears around the burner, keep the control knob pressed down for
a few seconds to allow the flame failure device to detect