10
Matrix ETERNITY Quick Start
3.
When the BRI port is configured in
TE mode
and connected as the
last
terminal on the S0 bus
(Multi-point configuration) as shown in figure 2.
Figure 2:
•
Termination
need not
be inserted in case 2 and 3 above, if the S0 bus itself
supports Termination resistors.
•
Termination need not be inserted if the BRI port of ETERNITY (configured in TE
mode) is connected as any terminal other than the last terminal on the S0 bus
(in a Multi-point configuration).
•
To set the 100
termination on the BRI port set the Jumpers J3 and J4 located
on the BRI Module (daughter board) of the card as shown in the table.
Feeding Power to Terminal Equipment
•
To feed power from ETERNITY to the terminal equipment connected to a BRI
port in the NT mode, change the position of the Jumpers J1 and J2 on the BRI
modules (daughter board) of the BRI Card as shown in the table.
Function
Jumper Position
J3
J4
To insert 100
termination (default position)
AB
AB
To remove 100
termination
BC
BC
Function
Jumper Position
J1
J2
To feed power on Tx and Rx wires (Phantom Power)
AB
AB
To feed power on separate pair of wires
BC
BC
No power to be fed to the terminal equipment (default position)
Open
Open
ISDN
Network
NT
BRI TE
ETERNITY
BRI Line
BRI TE
BRI TE
Other ISDN
Equipment
Other ISDN
Equipment
Содержание ETERNITY GE
