Matrix EPABX Vision-206S, Системное руководство

Страница: 75 / 235

Vision System Manual 75
Matrix
Communication Port
What’s this?
• The Vision has a communication port (DB-9 connector), which is used to download the configuration reports
SMDR Outgoing and SMDR incoming (ICA) reports on to the computer.
• The communication port uses RS-232C protocol.
• Pin details of the COM ports:
Pin No. Details
1 V+
2 RXD
3 TXD
4 NC
5 GND
6 V+
7 NC
8 NC
9 NC
Communication Port
• The Communication port parameters are fixed and not programmable. These are Baud Rate = 9600 bps,
Data bits = 8, Start bit = 1, Stop bit = 1, Parity bit = 0 and Flow control = none.
• On giving print command, corresponding configuration report is downloaded on the computer.
How to use it?
• To communicate with the computer, install communication software like ProComm, Bitcomm, Xtalk, Mirror, etc.
However if you have Windows 95 or Windows NT then its in-built software viz. HyperTerminal can be used.
For details, please refer section “Connecting Vision with computer using HyperTerminal”.
• Connect the communication port of the Vision with the communication port of the computer using Matrix
communication cable. Please contact Matrix dealer or Matrix Telecom Pvt. Ltd. for Matrix communication
cable.
(Matrix communication cable has 9-pin D-type female connector on both the sides and is 10 meters
long).
Connecting Vision with Computer
• Start your computer and go to command prompt. You get C:\>. Type CD ProComm. You get C:\ProComm>.
Type ProComm. You get C:\ProComm>ProComm. Press Enter. The computer runs the ProComm Software
and you get a full screen showing ProComm.
• Press Esc. You get a Status bar at the bottom of the screen.
• Press ALT-P to set the communication port of the computer for following settings:
• Baud rate = 9600 bps.
• Start bit = 1.
• Stop bit = 1.
• Parity bit = none.
• These settings are available in the option ‘11’. Hence press ‘11’ and press enter.
• Now press ‘20’ if you have connected the cable to COM port 1 (where normally a mouse is connected) and
press enter.
• Press ‘21’ if you have connected the cable to COM port 2 and press enter.
• To save the changes made in the settings, press 24.
• After some time you get a screen with a status bar at the bottom.
• Press ALT+F1 to create a file to store data. On pressing ALT+F1 the computer asks you a file name. Give
appropriate filename and press enter. The status bar at the bottom now shows
LOG OPEN
.
• Now on giving printing commands, the reports get downloaded on the computer (you can see them on the
screen). These reports can be saved in a file and can be retrieved, edited, deleted, printed, etc.