Matrix CRS 3.6 Li-12, Инструкция по эксплуатации

Страница: 16 / 75

16
time without reducing its service life. Interrupting
the charging procedure does not damage the
battery.
The Lithium-Ion battery is protected against
deep discharging by the “Electronic Cell
Protection(ECP)”. When the battery is empty, the
machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
· Do not continue to press the On/Off switch
after the machine has been automatically
switched off. The battery can be damaged.
The battery is equipped with a NTC temperature
control which allows charging only within a
temperature range of between 0°C and 45°C.
A long battery service life is achieved in this
manner.
When the battery indicator lights up while the
On/Off switch is
Depressed half way , then the battery has less
than 30% of its capacity and should be charged.
The charging procedure begins as soon as the
mains plug of the battery charger is plugged
into a socket outlet and the charge connector
is plugged into the socket on the bottom of the
handle.
Due to the intelligent charging method, the
charging condition of the battery is automatically
detected and the battery is charged with the
optimum charging current, depending on battery
temperature and voltage.
The battery indicator indicates the charging
progress. The indicator would
light up turn into
red or yellow
during the charging procedure.
When the battery indicator lights up green, the
battery is completely charged.
During the charging procedure, the handle of the
machine warms up. This is normal.
Disconnect the battery charger from the mains
supply when not using it for longer periods.
The power tool cannot be used during the charge
procedure; it cannot detective when inoperative
during the charging procedure.
Observe the notes for disposal.
Inserting Screwdriver Bits into the Bit
User instruction
a). Hold the handle with one hand and pull the
front part of the machine to the limit position.
b). Turn the bit-cylinder(3) to change the bits, the
bit will ready to be used when the user saw the
bit through the illumination window. (you will
feel a small click from the bit-cylinder(3) when
the bit is on the ready position)
c). Hold the handle and pull the front part back
to the initial position. (Now you should see the
selected bit on the front of the machine)
d). Push and hold the switch(6) with your finger
to test the machine. If the screw bit rotating
normally, your screw driver is now ready to work.
Change bits
a). Hold the handle with one hand and pull the
front part of the machineto the limit position.
b). Hold the machine on your hand, and push
the bit-cylinder(3) from right to the left with
your other hand until the bit cylinder rotate 180
degrees. (as in the picture)
c). Pull and release the bit-cylinder from front and
change bits/bit-cylinder.
Operation
· Starting Operation Reversing the rotational
direction
The rotational direction switch is used reverse the
rotational direction of the machine. However, this
is not possible with the On/Off switch actuated.
Switching On and Off
To save energy, only switch the power tool on
when using it.
Note: The power tool can only be switched on
when the sliding switch has been pushed to the
front position.