14
13
Figure 7
Ÿ
Match the mounting hooks (A, B,
C, D, E) on the plate with the
respective mounting slots (1, 2, 3,
4, 5) at the back of the device.
Refer figure 8.
Ÿ
Tilt the device to allow mounting hook A
into slot 1. Straighten the device and then
slide it down on the plate.
Ÿ
Use the M 3x6 screw provided to
you to secure the bottom mounting
slot on the plate. Match E to 5 as in
figure 8.
A
B
C
D
E
1
2
3
4
5
Figure 8
1
2
3
4
5
6
7
8
9
0
ESC
ENT
Apply Power to the COSEC Door Controller and wait for the reboot cycle to complete. At
power on, all four LEDs will glow and will be turned off at the end of booting cycle.
LED Status Indicators
Powering On the Device
The COSEC DOOR can be connected to the network over Ethernet, Wi-Fi, and Mobile Broadband.
The COSEC DOOR is pre-configured with a default IP address and Subnet Mask.
Default IP Address: 192.168.50.1
Default Subnet Mask: 255.255.255.0
You need to change the IP Address to connect the Door to the network. You can do this in one of
the following ways:
1. From the DOOR display
2. From the DOOR Webpage
Allowed
Denied
Alarm
Network
Ÿ
The ‘Network’ LED will start blinking with regular cadence indicating the current
network connection status as shown in the table below.
Orange
Blinking
Ethernet connection on, but not
connected to COSEC Server
Red
Blinking
No Ethernet connection
Network
Green
Blinking
Door is connected to the
COSEC Server
Color
Cadence
Meaning
LED
