Matrix C50, Руководство пользователя

Страница: 3 / 28

3
ENGLISH
SERIAL NUMBER LOCATION
ASSEMBLY
UNPACKING
Unpack the equipment where you will be using it. Place the carton on a level flat surface. It is
recommended that you place a protective covering on your floor. Never open box when it is on its side.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly and usage. Please do not wipe
this off. If you have difficulty, a light application of lithium grease is recommended.
SERIAL NUMBER
MODEL NAME:
MATRIX C50 CLIMBMILL
* Use the information above when calling for service.
TOOLS REQUIRED:
F
6mm L-Wrench
F
5mm L-Wrench
F
8mm L-Wrench
F
Phillips Screwdriver
PARTS INCLUDED:
F
1 Base Frame
F
1 Console Mast
F
1 Console Mast Cover
F
1 Handlebar
F
2 Handlebar Masts
F
2 Handlebar Covers
F
1 Rubber Gasket
F
1 Control Zone
F
1 Power Cord
F
1 Hardware Kit
WARNING!
DO NOT ATTEMPT TO LIFT THE ClimbMill! Do not move or lift
ClimbMill from packaging until fully assembled. FAILURE TO
FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
There are several areas during the assembly process that special
attention must be paid. It is very important to follow the assembly
instructions correctly and to make sure all parts are firmly tightened. If
the assembly instructions are not followed correctly, the equipment could
have parts that are not tightened and will seem loose and may cause
irritating noises. To prevent damage to the equipment, the assembly
instructions must be reviewed and corrective actions should be taken.
NEED HELP?
If you have questions or if there are any missing parts,
contact Matrix Customer Tech Support.
Before proceeding, find your
equipment’s serial number
located on a barcode sticker
and enter it in the space
provided below.