8
8
Figure 1: Spacer Configuration for 24”, 26”, 28”, & 30” pipe
Table 1 – Spacer Bolt Part Identification
4.0 INSTALLATION OF THE SADDLE MACHINE ON THE PIPE
4.1
Place the Saddle Machine squarely on the pipe, as close as possible to the cut line. All 4 spacer bolts
should make contact with the pipe.
4.2
Place the hook of the Boomer (Figure 2 item 1) into the Boomer Eye (Figure 4 Item 8) located on the
Saddle (Figure 4 Item 1).
4.3 Place the Spring Snap (Figure 2 Item 4) into the Boomer Eye (Figure 4 Item 8) on the other side of the
Saddle (Figure 4 Item 1).
4.4
In order to get a stable installation of the 5SA Saddle Machine, the Spring Snap (Figure 2 Item 4) of the
Boomer Assembly (Figure 2) must be adjusted on the Chain (Figure 2 item 3) so that the spring (Figure 2
Item 2) is stretched approximately 1/2" -3/4” (12 - 19mm) when the Boomer is closed.
4.5 When the Chain is properly adjusted, close the Boomer (Figure 2 item 1).
ITEM #
PART DESCRIPTION
PART #
QUANTITY REQUIRED
1
Spacer Bolt for 24” / 610mm pipe
03-0110-008
4
2
Spacer 1” / 25.4mm
04-0106-018
8
3
Spacer Bolt
03-0110-011
4
4
Hex Nut, 1/2 - 13
1H-12C0-000
4
5
Spacer Bolt Kit (includes all of the above)
03-05SA-KIT
1
WARNING: Improper tensioning of the boomer assembly or failure to latch the boomer assembly
may result in injury.
