Model No. BI-1000T
June 2011
Page
9
/
9
SPECIFICATION:
Model No.
BI-1000T
Voltage
220volt~240volt
50/60Hz
Ceramic Top Plate
Approx. 360*380mm
Electrical Power Consumption
Max. 1000w
Safety Device
z
Automatic Safety Shut-Off
z
Material Compatibility Detector
z
Small Object Detector
z
Overheating Protection Device
Remark:
The switching frequency is verified by different power setting, it’s
to be between 20 ~ 35 K Hz.
TROUBLE SHOOTING
1. If your induction range seems to be working improperly, it doesn't necessarily mean it's a faulty. In
all cases, check the following points.
2. If you fail to identify the problem, contact the after-sales service without delay.
If ......
It might be caused ......
No indication light when power "on"
Cable/terminal block is loosed
Broken circuit of fuse; or automatic switch in your house
Power supply stopped.
Heating indicator does not light-on,
Unsuitable cooking utensil,
Appliance fails to heat up
Utensil doesn't located at the center properly.
Utensil is small than 5cm.
Over-heating protection is activated.
Appliance suddenly stops heating
during
High ambient temperature.
Operation
Air entrance or outlet blocked.
Over-heating protection activated.
Error-Code: by beeper & by display
Definition
error-code by beeper
error-code by display
No pot/pan in 60seconds
beeper for 60seconds
(30 slow beeper)
“R”
Temperature sensor (on heating-coil): open or short
1long 2short
"E"
Over Voltage Protection: too high or too low
1long 4short
"U"
Over-heating: ambient temperature is to high
1long 7short
"F"
