Matermacc IRRIGAMATIC PRO35, Руководство пользователя

Страница: 11 / 30

Page 03
IRRIGAMATIC PRO 35
Ver. 0.x(x)
NEXT
BACK
3. INSTRUCTIONS FOR USE
3.1 START UP AND MAIN MENU
1 Connect power supply cables of electronic
console to a 12V d.c. voltage source
2 When switching electronic console on the LCD will
display name and version of its firmware
3 A series of messages follow
The first message informs about the execution of the
machine initialization. Flow valve closing If mounted
at the inlet.
FLUX OPEN
A second message: the BYP valve opens to make sure
speed is set to zero.
BYP OPEN
A third message confirms the device has been
initialized correctly:
INIT
COMPLETE
The electronic console goes to standby waiting for
new commands from the user who can access the
menus listed below:
5 Position the focus on the desired menu by
browsing the menus, turning the control to the
left or right.
6 Press the control
3.2 ACCESSING THE MENU
General procedure
The console then awaits new commands from the
user, who can access the menus listed below:
To access the menus mentioned above, proceed as
follows:
1. By turning the knob position the focus on the
desired menu by browsing the menus.
2. Press the knob.
3. If the menu is password-protected, the label
“PASSWORD“ appears, under which the
characters making up the necessary password
must be entered.
4. To enter a password:
A) Press the knob: the first character will
become
“0*“
, meaning that the character is
now editable.
B) Change the character by turning the knob to
the left or right
C) Confirm the selected character by pressing
the knob.
D) Position the focus on the next space by
turning the knob to the left or right.
E) Repeat steps a) to d) until the last character
has been entered, then position the focus on
and press the knob; if the password
is correct the console will show the first
value of the menu parameter; otherwise, it
will remain at the password menu. To exit
this menu, position the focus on , and
the console returns to the main menu.
4 The control unit therefore awaits new controls
provided by the user who can access the menus listed
below (normally the
“MANUAL”
menu is not
visible).
OPERATION
CALIBRATION
CONFIGURATION
CALENDAR
COUNTER
MANUAL