MATE ValuGrind, Руководство пользователя

Страница: 5 / 40

©2011 Mate Precision Tooling Dimensions in Inches(millimeters)
Page 5
Wheel Cleaning Procedure
Diamond grinding wheel cleaning needs will vary based on the amount of use as well as the hardness of
the material being ground. More use and softer materials will require more frequent cleaning. Follow one
of the procedures below when the ValuGrind Tool Grinding System does not seem to be cutting as freely
as it has in the past.
Wheel cleaning procedure A (Preferred):
1. Adjust the grinding wheel guard so that it will not interfere with the cleaning process.
2. Turn off the coolant valve.
3. Place the cleaning stick flat on the magnetic base.
4. Adjust the height of the grinding wheel so that it is approximately ¼”(6,35mm) above the cleaning
stick.
5. Hold the cleaning stick steady while making sure that your fingers will not come into contact with the
grinding wheel.
6. Start the grinding motor (leaving the coolant pump off) and let it come up to speed.
7. Hit the shut off switch and slowly lower the grinding wheel into the cleaning stick until the wheel
stops.
8. Raise the grinding wheel.
9. Repeat steps 3 through 8 four more times at different locations on the cleaning stick.
10. Re-adjust the grinding wheel guard back to factory recommendations.
11. Turn the coolant valve on.
Your wheel has now been cleaned and is ready for use.
Wheel cleaning procedure B (Optional):
1. Turn off the coolant valve.
2. Hold the flat side of the cleaning stick approximately ½”(12,70mm) below the grinding wheel. Make
sure that your fingers will not come into contact with the wheel.
3. Start the grinding motor (leaving the coolant pump off) and let it come up to speed.
4. Hit the shut off switch and slowly raise the cleaning stick into the grinding wheel until the wheel stops.
Note: Do not move the cleaning stick forward, backward, left, or right as you may damage the
grinding wheel.
5. Repeat steps 2 through 4 four more times at different locations on the cleaning stick.
6. Turn the coolant valve on.
Your wheel has now been cleaned and is ready for use.