Dimensions in Inches(millimeters) mate.com
Mate Precision Technologies • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone +1.763.421.0230 • 800.328.4492 • Fax +1.763.421.0285 • 800.541.0285
The Mate Logo is a registered trademark of Mate Precision Technologies Inc.
© Mate Precison Technologies Inc.
LIT01374 Rev B
MATE MT6AU USE AND
MAINTE
N
A
NCE INSTRUCTIO
NS
Figure 1 - Upper Assembly Keying
Figure 2 - Ultra Standard
Figure 3 - Ultra XT or Original
Figure 4 - Die Carrier
UPPER ASSEMBLY:
VFMA115315 (excludes A-station assemblies)
LOWER ASSEMBLY:
MFMA105315
DIE CARRIER ASSEMBLY:
N0MA00DC
LINE-UP TOOLS:
VAMTALT6A
MAXIMUM MATERIAL THICKNESS:
.236”(6mm)
MAX. TONNAGE:
5.4 Metric, 53kN or 6 US.
LUBRICATION:
Manual lubrication is required for all sliding surfaces
1x week or 20,000 cycles with DTE25, DTE26, SAE-20W or similar.
iRAM compatible but not required. See your Prima Power manual for proper
setup in iRAM machines
KEYING AND DIE INSTALLATION
1. Upper Assembly (Fig.1) offers 1 orientation key per complete A
station assembly. Different angle settings are achieved by selecting
different slots in the individual punch guides. Non-iRAM machines
rotate each station to the punching station position thus all stations
have the same angle setting configuration
a. Ultra Standard (Fig. 2): To change angle setting of punch, the
punch must be inserted into one of three internal slots of the
punch guide.
b. Ultra XT and Original Style Thick Turret (Fig.3): These guides
offer one internal slot and 2 external slots; 0°/90° and 90°/315°.
2. Die Carrier (Fig.4) offers multiple slots which accommodate the
various slot configurations of the different punch guides.
a. Install dies using a 2.5mm hex wrench for set screws
(P/N: SSS50139).
b. Torque to 4.0 N-m or 35 in-lbf.
c. After sharpenings, bring die height back to original die height of
1.187”(30.15mm) with metal shims.
Station keys are toward center
