25
1812411-11
6. Once the Black clip is clamped onto the battery [-] terminal, the Analyzer display will light up as shown.
(Fig.72):
7. Now you need to press key to proceed and the display will show as follows (Fig.73):
8. If the measured resistance reading is within limits, then it will display as follows (Fig.74).
9. If the measured resistance reading has gone beyond the limits, then it will display the screen as follows
(Fig.75).
Note:
The above (Fig.75) indicates that the ground contact from the engine body to the battery is bad. Check
for rusted or corroded point of contacts. If found, dismantle it for cleaning or replace before fixing.
Repeat the test again after fixing.
10. If you did not follow the right procedures during the testing, it will display the results as follows (Fig.76) below:
11. To printout the results, just press key on the Analyzer, the printer will start printing.
12. To exit the program, pressing the key at any moment will exit and return back to the main menu screen
(Fig.65).
Fig.75
80.58 m
Fig.72
Fig.73
Fig.74
Fig.76
20.58 m
