Matchmaster 05MM-RE03, Руководство пользователя

Страница: 12 / 16

Function Switch Selection (A,B,C)
You will find slide switch on the bottom of receiver if you
remove the Plastic case. The positions A,B,C are used to set the
receiver to different remote controls .The factory setting is on
position B (Most of remote control use position B).
Interference
Your extender can cause TV or radio interference even when
it is operating properly. To determine whether your extender
is causing the interference if your receiver does not function
properly, the two LEDs(A & B)will blink continuously or one
LED will blink even without you using a remote control. IF THIS
OCCURS PLEASE SEE BELOW.
1. Move your transmitter away from the receiver
and check then realign.
2. Reduce the antenna length.
3. Select position “C” of slide switch on the back of the receiver.
Please remove the plastic cover first.
4. If you cannot eliminate the interference,
please contact your dealer.
A: 56KHz(a few special remotes)
B: 38KHz(most of remote controls)
C: Sensitivity lower(external interference etc.)