14
15
model no. 054-0246-8 | contact us 1-800-689-9928
OPERATING INSTRUCTIONS – WET VACUUMING
Verify that the power cord is disconnected from
the outlet. Verify that the container is clean and
free of dust and dirt.
Fit the desired nozzle onto the vacuum hose.
Remove the dust filter, and install a foam filter
over the filter basket, and place the top section
back on the container.
DO NOT USE dust filter for wet materials.
Verify that the switch is in the “O” position
before plugging the power cord into the outlet.
WARNING!
Before starting, be sure to read, understand, and apply Section 1, entitled “Safety Warnings”. Reminder: DO
NOT vacuum hazardous substances.
REMEMBER!
The foam filter must be removed after wet vacuuming, and a cartridge filter must be installed before dry
vacuuming again.
After use, flip the switch to the “O” position and
unplug the power cord, then empty and dry the
container.
Turn the motor on by flipping the switch to the
“I” position.
WET VACUUM OPERATION
WET VACUUM OPERATION
1
3
2
5
6
4
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse the nozzle completely in the liquid; leave a
gap at the tip of the nozzle opening to allow air inflow.The machine is fitted with a float valve that stops the
suction action when the containereaches its maximum capacity. You will notice an increase in motor speed.
When this happens, turn off the machine, disconnect from power supply, and drain the liquidinto a suitable
receptacle or drain. To continue vacuuming, refit the container with the draincap. After wet vacuuming,
turn the machine off and remove plug from power supply. Empty the container, clean and dry the inside
and outside before storage.
