28
Preparation of the product
Separe the flowers from the branches, without leaving
branch stems with the flower.
When pelling in wet, it’s recommended to remove the largest
leaves before introducing material in the Tumbler. You can
speed up the proccess by using our MT Standard machine.
The big leaves are often rolled with the flower, reducing the
possibilities of the leaf of being cutt by the blade. Removing
the excess of material will help you to achieve a final product
of quality and increase the performance.
How to use the machine.
Take into account several aspects:
1- The inclination
2- Load speed
3- The time of the flower in the drum.
The recomnendation is to install the machine on a flat
Surface. With a charge time of approximately a handful of
lowers every 30* seconds and with a time in the drum of 30-
45 seconds.
When putting the new product in the machine, you’ll notice
that it pushes the flowers that are already inside the drum.
* The loading time can vary depending on the conditions of
your product.
Quality Control
Check the appearence of the flower when leaving the drum.
If the flower is not clean enough, it is usually because it
hasn’t been enough time in the drum. To improve the quality
you should reduce the loading speed or reduce the
inclination.
The ideal amount that the machine needs is half a drum.
