MasterForce Utila-Tool 241-0853, Руководство оператора

Страница: 4 / 11

6 7
provide for a secure stance. The power tool is guided more securely with
both hands.
√ Keep your workplace clean. Blends of materials are particularly dangerous.
Dust from light alloys can burn or explode.
√ Do not scrape wet or dampened materials (e.g., wallpaper) or on moist
surfaces. Penetration of water into the machine increases the risk of an
electric shock.
√ Do not treat the surface to be worked with solvent-containing fluids.
Materials being heated by the scraping can cause toxic vapors to develop.
√
Exercise extreme caution when handling the scraper accessory. The
accessory is very sharp; danger of injury.
√ Use only the original MASTERFORCE
TM
Uitila-Tool accessories and the
other accessories specified in this manual.
√ Only use application accessories in good condition. Do not use them if they
are torn or worn.
√
Do not restart a cutting operation in the workpiece. To resume a cutting
operation: while keeping the tool from contacting the workpiece, allow the
tool reach full speed and then carefully guide the cutting accessory into
the cut.
√ Keep your hands away from the cutting area. Do not reach under the
material being cut.
DESCRIPTION
KNOW YOUR UTILA-TOOL
TM
(Fig. 1)
Before attempting to use this Utila-Tool
TM
, familiarize yourself with all of its
operating features and safety requirements.
WARNING: The safe use of this product requires an understanding of the
information on the tool and in this operator’s manual, as well as knowledge of
the project you are attempting. Before use of this product, familiarize yourself
with all operating features and safety rules.
COMPATIBILITY WITH OTHER ACCESSORIES
The Utila-Tool
TM
can be used with Fein
®
, Rockwell
®
and Dremel
®
brand
oscillating tool accessories. Use the adapter when using Dremel
®
brand
oscillating tool accessories.
(Fein is a registered trademark of C & E Fein GmbH. Rockwell is a registered
trademark of the Positec Group. Dremel is a registered trademark of Credo
Technology Corporation.)
MULTIFUNCTION DRIVE SHAFT SYSTEM
The Utila-Tool
TM
has a multifunction drive shaft system that allows the tool to
be used for dry sanding of small surfaces, corners and edges, for scraping,
and for sawing thin steel sheet, wood and plastic by attaching different
application tool supplied.
Fig. 1
On/off switch
Vent
Flange with bolt
Hex key
Clamping bolt
Adapter for Dremel
®
brand oscillating tool
accessories
Drive
shaft
Variable-speed dial