MasterForce FlexPower 241-0432, Руководство оператора, Страница: 7 / 20

Page 6
SAfETy INSTRUCTIONS
SERVICE
1.
Have your power tool serviced by a
qualified repair person using only identical
replacement parts.
This will ensure that
the safety of the power tool is maintained.
SPECIfIC SAfETy RULES fOR
RECIPROCATING SAW
1. Use battery only with charger listed.
battery pack Charger
252-8024
252-8028
252-8029
252-8030
252-8031
252-8032
252-8033
252-8034
252-8036
252-8037
252-8044
WARNING:
Hold tool by the
insulated gripping surfaces when
performing an operation when the
cutting tool may contact hidden wiring or its
own cord.
2. If you are not thoroughly familiar with
the operation of a reciprocating saw,
obtain advice from a qualified person.
3. When servicing, use only identical
replacement parts.
4.
Avoid cutting nails and staples when
operating with the wood blade. Inspect the
workpiece carefully and remove all nails and
staples before operation.
5.
Make sure that the blade always
extends beyond the shoe and the workpiece
throughout the stroke.
Blades may shatter if
they strike the workpiece or shoe.
6.
Do not cut an oversized workpiece.
7. Check for proper clearance beyond the
workpiece before cutting, so that the blade
will not strike the floor, workbench, etc.
8.
Make sure that the blade is not
contacting the workpiece before the
switch is turned on.
9.
keep the saw blades clean and sharp.
10. Use only correct blades. Always
use blades recommended for the type
of workpiece.
11.
Do not leave the tool running.
Operate
the tool only when hand-held.
12.
Always release the switch to “Off” and
wait for the tool to come to a complete
stop before removing the blade from
the workpiece.
13. keep the handle dry, clean, and free
from oil and grease.
Always use a clean
cloth when cleaning. Do not use solvents,
brake fluids, gasoline or other petroleum
products to clean the tool; they may damage
plastic parts.
14.
Do not operate this tool in a gaseous
or explosive environment or near
explosive materials.
15. Never force the tool. Apply firm pressure
against the saw’s pivot shoe for the sawing
operation--too little or too much pressure
could cause jumping or vibration and may
break the blade.
16.
Never operate the saw without the
pivot shoe in position.
The spindle may
strike against the workpiece and damage
the reciprocating mechanism.
17.
Do not touch the blade or the workpiece
immediately after the sawing operation.
They may be extremely hot and could burn
your skin.
18.
Hold the tool firmly with two hands
when operating the tool.
19. Do not reach underneath the
workpiece.
The proximity of the blade to
your hand is hidden from your sight.